- Adjustable V OUT range from 0.80V to 1.8V
- The wide V bias supply operates from 3.0V to 5.5V
- 10μF ceramic capacitors operate stably
- The voltage difference is 130 mV (typical) at 1.5A load current
- Precision output voltage in all line and load conditions:
- ± 1.5% V ADJ is T J = 25 ° C
-
± 2.0% V ADJ is 0°C ≤ T J ≤ +125 ° C
-
± 3.0% V ADJ is -40°C ≤ T J ≤ +125 ° C
- Overheat and overcurrent protection
- It is available in 8-lead PSOP, 7-pin TO-220 and 7-pin TO-263 packages
- -40°C to +125°C operating junction temperature range
illustrate
The LP38852-ADJ is a high current, fast response time that can keep the output regulator with very low input and output voltage drop voltage regulation. Fabricated in the CMOS process, the device operates on two input voltages: V BIAS provides the voltage to drive the gate of the N-MOS power transistor, while V IN is the input voltage to supply power to the load. The use of external bias rails allows partially to work at ultra-IN voltage low V. With bipolar regulators, the power consumption CMOS architecture provides very low quiescent current at any output load current. With an N-MOS power wide bandwidth but minimal external capacitance, the transistor uses the effect of maintaining loop stability.
The device's fast transient response allows it to be used after powering the DSP, the core voltage of the microcontroller, and the switching power supply regulator. The device is available in TO-220 and TO-263 7-pin packages.
Differential pressure: 130 mV (typical) at 1.5A load current.
Low ground pin current: 14 mA (typical) at 1.5A load current.
Soft start: Programmable soft-start time.
Precision ADJ Voltage: ± 1.5% T J = 25 °C and ± 2.0 °C 0% ≤ T J ≤ +125 °C in all line and load conditions
apply
- - Desktops, laptops and graphics cards, servers
- - Gaming set-top boxes, printers and copiers
- Server cores and I/O power supplies
- DSP and FPGA power supplies
- SMPS rear regulator
|